tattoos

Friday, September 30, 2011

lincoln continental

The Lincoln Continental is an automobile which was produced by the Lincoln division of Ford Motor Company from 1939 to 1948 and again from 1956 to 2002. Despite often sharing underpinnings with less-expensive Fords in more recent years, the Lincoln Continental had usually been a distinctively platformed and styled, highly equipped luxury car in the course of its long history.

The flagship Lincoln model during most of its run, the Continental name conveyed special cachet in the product line. During the 1980s, the Continental was downsized from a full-size to a mid-size Ford Taurus platform; this introduced the Continental to a wider range of competition from Europe and Japan. After the Continental was discontinued in 2002, it was largely replaced by the Lincoln LS V8.
The first Lincoln Continental was developed as Edsel Ford's one-off personal vehicle, though it is believed he planned all along to put the model into production if successful. In 1938, he commissioned a custom design from the chief stylist, Eugene T. "Bob" Gregorie, ready for Edsel's March 1939 vacation. The design, allegedly sketched out in an hour by Gregorie working from the Lincoln Zephyr blueprints and making changes, was an elegant convertible with a long hood covering the Lincoln V12 and long front fenders, and a short trunk with what became the Continental series' trademark, the externally mounted covered spare tire.

The car could be considered a channeled and sectioned Zephyr that did not even have the bulge that in the Zephyr (and in some other cars) replaced the running-board at the bottom of the doors. This decrease in height meant that the height of the hood was much closer to that of the fenders. There was hardly any trim on it at all, making its lines superb. This car is often rated as one of the most beautiful in the world.
The custom car for the boss was duly produced on time, and Edsel had it delivered to Florida for his spring vacation. Interest from well-off friends was high, and Edsel sent a telegram back that he could sell a thousand of them. Lincoln craftsmen immediately began production on the Continental convertible, and even a rare few hardtop models. They were extensively hand-built; the two dozen 1939 models and 400 1940-built examples even had hand-hammered body panels, since dies for machine-pressing were not constructed until 1941.




No comments:

Post a Comment

 

blogger templates | Blogger